Audi 80/Avant (B4)

since 1991-1995 of release

Repair and car operation



Audi 80/Avant
+ Technical specification
+ Engines
+ System of production of the fulfilled gases
+ cooling System
+ Fuel tank and fuel pump
+ Air filter and airintaking channels
+ injection System
+ Coupling
+ Transmission and transmission
+ Suspension bracket and steering
+ Brake system
+ Anti-blocking system of brakes
+ Wheels and tires
+ Body electrosystem
+ ignition System
- Lighting
   Lighting check
   Spare lamps
   Replacement of lamps
   Removal of headlights
   Check of adjustment of headlights
   Fog lights
   Independent installation of fog lights
   Indexes of turns
   Back lamps
   Illumination of registration plates
   Other lighting devices
   Dashboard illumination
+ Signalling devices
+ Devices and auxiliary devices
+ Heating and ventilation
+ body Elements
+ Search of malfunctions
+ Specifications




Removal of headlights

Elements of the main headlight (on an illustration of a headlight of models with 4-and 5-cylinder engines)

1–rasseivatel;
2–rubber sealant;
3–a reflector with the lamp case;
4–fixing brackets;

5–engine of regulation of a tilt angle of headlights;
6–cap;
7–decorative slip;
8–headlight case.


For removal of a headlight it is necessary to turn out the bolts designated on an illustration by shooters.


 PERFORMANCE ORDER

  1. Preparation, see in the section Replacement of lamps.
  2. To remove a strip under headlights (see head body Elements).
  3. Behind on a headlight to weaken a cap (and), to disconnect the multicontact tip and the boss of a parking light.
  4. To stretch a plait of wires with a cover through an opening in the block headlight case.
  5. To turn out two fixing screws above from the body panel; two more under a headlight.
  6. To take out a headlight forward.
  7. Models with 4-and 5-cylinder engines: in addition to remove the case of the index of turn.

Headlight analysis

If glass of a headlight is damaged or the reflector grew dull, it is not so necessary to replace at once all headlight. Both details it is possible to get separately, having specified the producer (Hella or Bosch firm). For installation you should disassemble the removed headlight.

 PERFORMANCE ORDER

  1. To open all fixing latches round headlight glass.
  2. To remove a rasseivatel and a sealing elastic band.
  3. Carefully to hook the chromeplated decorative slip round a reflector and to extend it.
  4. To rotate both adjusting screws until it will be impossible to raise a reflector a hand.
  5. To turn out the screw with a crosswise shliyets from knot of motionless fastening of a reflector.
  6. After assembly to adjust a headlight.

 Help: rasseivatel and reflectors (reflectors) of headlights it is at all unessential to buy from Audi. The shops trading in spare parts, receive them directly from the producer (Hella or Bosch).