Audi 80/Avant (B4)

since 1991-1995 of release

Trunk lid at a sedan

The lock and zamkovy drive in a cover of a luggage compartment of a sedan of Audi 80


1–lock; 2–the movable button of connecting draft between the lock and the press button;	3–press button; 4–connecting bent for to system of locks with the central management.

Removal

PERFORMANCE ORDER

To open a cover.
A few to cast away a covering of a luggage compartment above the left back dimension.
To separate shtekerny connection of wires to a cover of a luggage compartment and to pass tips via the sealing plug in metal.
If the car is equipped with system of locks with the central management, it is necessary to disconnect a hose to a lock drive at cover loops.
On the right and at the left to cast away and remove lock brackets on pneumatic springs. After that it is possible to wring out pneumatic springs from spherical heads.
Supporting a cover together, to turn out on the right and at the left two bolts in loops.
To uncover loops.
It is in addition possible to disconnect loops from a body.

Adjustment of a cover of a luggage compartment

Sedan

PERFORMANCE ORDER

It is necessary to achieve an identical gap between the right and left details of a body and a trunk lid (about 4-5 mm). Also near back glass the distance to a cover should be identical on the right and at the left.
It is necessary to regulate after weakening of fixing bolts of loops on a cover of a luggage compartment.
Besides, the cover should coincide on height with wings. It can achieve after weakening of fixing bolts of loops on a lateral wall.
If the trunk lid knocks or is badly closed, it is possible to adjust the lock buffer on the right and at the left above on a lateral part.
To weaken and shift up or down a fixing bolt, then to tighten again. The lock buffer is established correctly if it without tension adjoins to the closed cover.
To check landing and closing of a cover of a luggage compartment, if necessary отюстировать a locking plate of the lock of a luggage carrier.
The block of headlights in a cover should defend from headlights in a lateral part approximately on 8 mm. It can be reached by moving of the block of headlights in their longitudinal openings.

Removal of the lock of a luggage carrier

Sedan

PERFORMANCE ORDER

To open a cover of a luggage compartment.
To remove an internal covering under the press button of the lock of a luggage carrier.
Button removal: to take aside a lock bracket on driving draft and to remove draft.
To disconnect shtekerny connections for the microswitch of system of locks with the central management.
To turn out two nuts, to remove in the direction inside the press button with lock cylinders.
Removal of a zamkovy part: to disconnect driving drafts from the press button (to take aside a lock bracket), to separate shtekerny connection.
To turn out two six-sided nuts from below on the lock. To take out the lock in the direction down.
At installation of a zamkovy element to adjust length of driving bent for to the press button.
The movable button in the middle of connecting draft to shift back so that halves of draft appeared freely inserted each other.
At an open trunk lid to put a latch of the lock to situation "is closed".
To insert a six-millimetric drill into an opening of a zamkovy element, to fix a latch.
In this situation to fix one in other carving sites of halves of draft and to stop the movable button.
To remove a drill.