Audi 80/Avant (B4)

since 1991-1995 of release

Repair and car operation



Audi 80/Avant
+ Technical specification
- Engines
   Basic elements
   Greasing system
   Case ventilation
   Visual check of the engine
   Running in of the new engine
   Engine service life
   Nominal and maximum frequency of rotation
   Restriction of frequency of rotation
   Measurement of pressure of compression
   List of malfunctions
   Provorachivaniye of the engine
   Hydraulic pushers
   Works on the GRM gear belt
   List of malfunctions
   Removal and installation of a head of the block of cylinders
   Removal and engine installation
+ System of production of the fulfilled gases
+ cooling System
+ Fuel tank and fuel pump
+ Air filter and airintaking channels
+ injection System
+ Coupling
+ Transmission and transmission
+ Suspension bracket and steering
+ Brake system
+ Anti-blocking system of brakes
+ Wheels and tires
+ Body electrosystem
+ ignition System
+ Lighting
+ Signalling devices
+ Devices and auxiliary devices
+ Heating and ventilation
+ body Elements
+ Search of malfunctions
+ Specifications




Visual check of the engine

 PERFORMANCE ORDER

  1. Examine the engine from above and from below.
  2. Places poorly soiled by oil is not a reason for the concern, all vypotevayut engines from time to time a small amount of lubricant means.
  3. However you should find out the reason of emergence of oil spots under the parked car and considerable oil dirt on the engine case.
  4. To clear the engine means for cleaning of the engine or the steam-ejecting device.
  5. After a trial trip (enough several kilometers) to check, oil from where acts.

Possible places of leak

We made the short list of places in which at the Audi engine oil can act:

  • Sealing laying of a cranked shaft, camshaft (ов) and intermediate shaft (the 4-cylinder engine). These places are closed by a casing of a gear belt
  • Sealing laying of a cover of a head of the block of cylinders.
  • Sealing laying of a head of the block of cylinders.
  • Sealing laying of the distributor of ignition (model with 4-and 5-cylinder engines).
  • Switches with a hydraulic actuator.
  • Sealing laying of the oil filter.
  • Sealing laying of fastening of the oil filter (model with 4-cylinder engines).
  • Sealing laying of the oil pallet.
  • Sealing laying of a cranked shaft behind (oil acts on a dividing arch the transmission engine/case).

 Help: it is possible to carry out a wash of the engine in so-called harvest parks in which it is possible to use the steam-ejecting device for self-service. At strong pollution it is recommended to sprinkle a little before a sink on the engine means for cleaning and to leave it to operate during any time. Surely take with itself working clothes.