Audi 80/Avant + Technical specification + Engines + System of production of the fulfilled gases + cooling System + Fuel tank and fuel pump + Air filter and airintaking channels + injection System + Coupling + Transmission and transmission + Suspension bracket and steering + Brake system + Anti-blocking system of brakes + Wheels and tires + Body electrosystem + ignition System - Lighting Lighting check Spare lamps Replacement of lamps Removal of headlights Check of adjustment of headlights Fog lights Independent installation of fog lights Indexes of turns Back lamps Illumination of registration plates Other lighting devices Dashboard illumination + Signalling devices + Devices and auxiliary devices + Heating and ventilation + body Elements + Search of malfunctions + Specifications
|
Fog lights
|
Removal of fog lights at models with 4-and 5-cylinder engines – the first step: after removal of a level (3) there are available fixing bolts (2). The position (1) designates the adjusting screw. |
|
Removal of fog lights at models with 4-and 5-cylinder engines – the second step: after an otzhimaniye of a wire bracket (1) it is possible to open a cover (2). |
|
Fog light of model with the 6-cylinder engine: 1–fixing pin; 2–case; 3–lamp; 4–cover. |
Replacement of lamps
|
- Models with 4-and 5-cylinder engines: to disconnect a level outside at a fog light. To turn out two fixing bolts located below.
- To pull out a fog light forward, thus to deduce fixing ledges from directing in a bumper.
- To remove a back cover.
- Models with 6-cylinder engines: to remove the index of turns.
- To turn out two fixing bolts and to pull out a fog light from a bumper in the direction to outer side of the car.
- To wring out a wire clip and to remove a back cover.
- All models: to compress brackets for spring fastening at fastening of a lamp and to cast away them.
- To extend a lamp.
- At installation of the new filament lamp the boss of a lamp should get precisely to dredging in a reflector.
- To pay attention at installation: at first to insert a headlight into an opening, and then to hang a fixing pin in a bumper in the direction to the car middle.
|
|
|
|