- You can pierce cable isolation by means of a control lamp with needle contact and establish, what cables are energized.
- Choose the electroscheme corresponding to the required switch.
- At first it is necessary to check, whether запитаны switches; for this purpose it is necessary to include ignition or lighting several times.
- Then it is checked, whether carries out the switch in the relevant situation tension further on a chain.
- On an example of the switch of the lock of ignition check looks as follows:
- To remove a combination of devices that wires became available.
- To connect a wire of a control lamp to "weight".
- To pierce a control needle isolation of a checked wire.
- Both thick red wires of the plug 30 should be constantly energized the accumulator.
- The gray and yellow plug of the R-chain is in «position of rest» the ignition lock energized, at key turn giving of a food stops.
- The black and yellow wire of the plug X is energized only in the provision of a key «ignition is included»; as well as a thin red wire to a buzzer of a parking light and radio.
- Black wire of the plug 15 запитан in provisions «ignition is included» and "start".
- The red-black wire of the plug 50 of the order of start of a starter of the engine is energized only in the situation "start".
|
|