Audi 80/Avant + Technical specification + Engines + System of production of the fulfilled gases + cooling System + Fuel tank and fuel pump + Air filter and airintaking channels + injection System + Coupling + Transmission and transmission + Suspension bracket and steering + Brake system + Anti-blocking system of brakes + Wheels and tires + Body electrosystem + ignition System + Lighting + Signalling devices + Devices and auxiliary devices + Heating and ventilation - Body elements Front bumpers Forward part of the car Cowl Wings Moldings Doors External rear-view mirrors The forward and back flew down Trunk lid at a sedan Back door of the versatile person Rear bumper Movable hatch Pro-cleaning of openings for a water drain Control of anticorrosive protection of the bottom of a body Salon Seats + Search of malfunctions + Specifications
|
Wings
|
The wing (3) is presented in drawing together with hinged details:
1–back face slip; 2–podkrylok. |
The demountable executed only forward wings. Back wings are welded, and there is nothing to do to amateur mechanics.
Removal of facing of forward wheel niches
|
- To remove the corresponding forward wheel.
- To remove plastic дюбель at the very bottom at back edge of a bumper.
- To remove боковины a bumper from arms on a wing. For this purpose to press on a bumper in the direction down at height of fixture and at the same time to take away it from a body.
- To unscrew all fixing bolts/nuts of facing of a wheel niche (podkrylok).
- To remove plastic дюбели a forward bolt.
- In front to unscrew a fixing nut a podkrylka.
- To turn a rotary lock on connection with the bottom protection of a motor compartment on 90 ° counter-clockwise (to the left).
- To remove facing of a wheel niche through a rasporny bolt and to wring out inside from an external contour of a wheel arch.
- At installation very carefully to tighten plastic nuts and bolts with a crosswise shliyets, differently it is possible to break a plastic carving!
|
|
Wing removal
|
- To remove a podkrylok.
- To remove a bumper.
- To turn out at bottom edge of a wing on one screw with a crosswise shliyets or screws with a zvezdchaty head in front and behind.
- To turn out the screw below cut for a bumper.
- In a back part of a wheel niche to turn out the screw from a cross-piece, and one more is a little lower.
- To open a forward door.
- To turn out a bolt over hinges.
- To turn out six-sided bolts on the upper edge of a wing; before it to remove porolonny laying.
- To remove a wing.
|
|
Installation covered
|
- If the new wing is established, it is necessary to remove an arm and a back face slip from an old wing and приклепать (in a workshop) to the new.
- To remove the remains of a sealing tape on back edge of fastening of a wing.
- To paste a new sealing cord (spare part AKD497 010 04R10 number) in diameter of 7 mm.
- To establish a wing.
- To establish distance to a cowl at not tightened fixing bolts of the upper edge of a wing. It should make 4,5 — 5,5 mm.
|
|
|
|