Audi 80/Avant + Technical specification + Engines + System of production of the fulfilled gases + cooling System + Fuel tank and fuel pump + Air filter and airintaking channels + injection System + Coupling + Transmission and transmission + Suspension bracket and steering + Brake system + Anti-blocking system of brakes + Wheels and tires + Body electrosystem + ignition System + Lighting + Signalling devices + Devices and auxiliary devices + Heating and ventilation - Body elements Front bumpers Forward part of the car Cowl Wings Moldings Doors External rear-view mirrors The forward and back flew down Trunk lid at a sedan Back door of the versatile person Rear bumper Movable hatch Pro-cleaning of openings for a water drain Control of anticorrosive protection of the bottom of a body Salon Seats + Search of malfunctions + Specifications
|
External rear-view mirrors
Removal
|
- Electric regulation of rear-view mirrors: to take the mirror case aside.
- Now both fixing screws in a mirror leg become visible – to turn out them.
- To separate the multicontact tip directly on a mirror leg.
- Mechanical regulation of rear-view mirrors: to remove a door covering.
- To turn out the forward screws connecting the external panel of a door from boxes, both back only a few to weaken.
- Now it is possible to stretch a mirror drive between panels.
- To take the mirror case aside, to turn out fixing screws in a mirror leg.
- At installation to use the corresponding fixing openings at doors.
- Driver's door: to use a carving opening in front below (if there are two) and behind above.
- Door of the forward passenger: to use a carving opening in front above and behind below and above.
- Again to establish a window frame.
|
|
|
Help: you will find the description of work and control of an electric window regulator in head «Devices and auxiliary devices». |
At the left: mirror removal by means of a wide shovel. It is recommended to put on working gloves – in case glass will break.
On the right: adjustment of a free wheeling of a mechanical drive of a rear-view mirror can be carried out, turning adjusting screws at the removed castors with a longitudinal nakatka.
Mirror replacement
Glasses of mirrors keep both in electricly, and in mechanically adjustable mirrors only on latches. Removal:
|
- To put on working gloves in case glass will break.
- To insert from below a wide shpatel or a plastic plate under glass of a mirror and to take out it from latches.
- If necessary to repeat the same operation from above.
- At installation to insert glass in directing and to press before fixing.
- In gloves to press the glass middle.
|
|
Adjustment of a drive of a mirror
It is possible to establish driving cables of mechanical regulation of mirrors so that there was no too big free wheeling of adjusting castors. For this purpose very small screw-driver is required.
|
- Castors with a longitudinal nakatka of the mechanism of regulation of external rear-view mirrors to remove in the direction up, if necessary to help a screw-driver.
- For the driving direction (up/down; to the right/on the left) two answer always located the friend opposite to the friend of the screw. At one of them left, at another the right carving.
- Regulation: the A1 screw carefully to turn to the right, to those small resistance will not be felt yet.
- The A2 screw to turn to the left, to those small resistance will not be felt yet.
- Too most to repeat with bolts В1 and В2.
- To check correctness of installation: the mirror is easily regulated, but the free wheeling remains maximum.
|
|
|
Helps: if glass of an external mirror shivers during a trip, means, the adjusting mechanism is established too freely – дозатянуть.
Too legkokhodny regulation of mirrors leads to that already insignificant touches a sleeve to castors with a longitudinal nakatka change the provision of mirrors. In that case it is necessary to establish it a little more tightly. |
|
|