Audi 80/Avant (B4)

since 1991-1995 of release

Repair and car operation



Audi 80/Avant
+ Technical specification
+ Engines
+ System of production of the fulfilled gases
+ cooling System
+ Fuel tank and fuel pump
+ Air filter and airintaking channels
+ injection System
+ Coupling
+ Transmission and transmission
+ Suspension bracket and steering
+ Brake system
+ Anti-blocking system of brakes
- Wheels and tires
   Wheels
   Wide tires and wheels
   Pressure check in tires
   Control of a condition of tires
   Wheel replacement
   Control of an inhaling of wheel bolts
   Balancing of wheels
   Purchase of new tires
+ Body electrosystem
+ ignition System
+ Lighting
+ Signalling devices
+ Devices and auxiliary devices
+ Heating and ventilation
+ body Elements
+ Search of malfunctions
+ Specifications





Wheels

The important size of a wheel is depth of a press fitting of "d". This size designates distance between the middle of a wheel and surfaces of a prileganiye of a rim to a wheel nave.

At the left: suitable wheel bolts for steel and light-alloy wheels from Audi can be distinguished on deepenings on a bolt head.

On the right: the steel wheel for Audi 80 so looks. In metal the following designations are beaten out:

1–wheel designation;
2–depth of a press fitting;
3–detail number.

On Audi 80 cars wheels with the following designations can be established: 6 J x 15 ET 37 or 7 J x 15 ET 37. Sometimes it is possible to meet on a rim additional designation «N 2». Figures and letters designate the following:

6 or 7: the width of a rim in inches, is measured between boards закраины rims cross-section to the direction of rotation of a wheel.
J: designation of height of a board.
х: designation of a deep rim.
15: diameter of a rim in inches, is measured from a board to a board (landing diameter of the tire).
ET 37: depth of a press fitting of a wheel of 37 mm.
Н2: designation of a deep wheel with ring corbels on landing regiments. Two ledges inside in the rim basis at lateral loading (sharp passing of turn at low pressure of air in tires) let's to boards of the tire come off with закраины.

These standard designations specify only the main sizes of the tire, but not data specific to everyone car, as, for example, number of openings for fastening of a wheel or diameter of these openings.

Wheel bolts and wheels – the uniform block

In the constructive relation wheel bolts and wheels represent the uniform block and consequently they cannot be applied separately. Conic landing on fixing openings of a wheel is precisely coordinated with cones of wheel bolts. Other forms of a cone cannot guarantee reliable fastening of a bolt and by that wheel.

For established and allowed to application at Audi plants wheels (steel and light-alloy) it is possible to use only this way called bolt with a koronchaty head (number of a detail 431 601 139 And). He can be distinguished on special deepenings above on a bolt head. For the rims bought in shop of spare parts, other rules are applicable. Probably, it is necessary to buy wheel bolts of the corresponding producer!

Wheels for winter tires

Winter tires should be bought at once with suitable steel rims. It though is more expensive during the first moment, but will save means at a perebortirovka. In the shops trading in tires, it is quite often possible to get complete sets at the favorable price. Standard wheels of 6 J will be suitable for winter tires x 15. It is also possible to get second-hand wheels.

Light-alloy wheels under the influence of salt for a posypaniye of roads can корродировать up to full unfitness. Therefore it is necessary to eliminate as soon as possible damages of a protective varnish covering them. The one who uses in the winter light-alloy wheels, should supervise their condition at each wash of the car.