Audi 80/Avant
+ Technical specification
+ Engines
+ System of production of the fulfilled gases
+ cooling System
+ Fuel tank and fuel pump
+ Air filter and airintaking channels
+ injection System
+ Coupling
+ Transmission and transmission
+ Suspension bracket and steering
+ Brake system
+ Anti-blocking system of brakes
- Wheels and tires
Wheels
Wide tires and wheels
Pressure check in tires
Control of a condition of tires
Wheel replacement
Control of an inhaling of wheel bolts
Balancing of wheels
Purchase of new tires
+ Body electrosystem
+ ignition System
+ Lighting
+ Signalling devices
+ Devices and auxiliary devices
+ Heating and ventilation
+ body Elements
+ Search of malfunctions
+ Specifications
|
Wheel replacement
|
|
If the serviceable wheel balanced on the car – for example after control of a condition of brakes is established, it needs to be tightened on a wheel nave in the same position, as before removal. For this purpose it should be noted situation on a rim (2) and a nave of a wheel (1). |
Wheel replacement in a way – not absolutely simple business. Bolts for fastening of a wheel can appear prirzhavevshy or at the last replacement of wheels in a workshop them "slammed" to percussions gaykoverty (instead of as it is necessary to tighten the moment of 110 N • м). In this case the onboard tool to you will not help, is necessary the powerful key for an inhaling of bolts of fastening of wheels or a cross-shaped natural the put-on piece of a pipe for lengthening of the lever of force.
|
|
- To put the car on the parking brake and to include the first or reverse gear or parking blocking.
- On the road to turn on the alarm light system and to establish a sign of an emergency stop.
- To block wheels of the opposite side, for example stones or wooden whetstones that they did not move.
- Insert fingers into openings of a wheel cap and remove it.
- If on the car there are light-alloy wheels with secret fastening, insert a screw-driver into lateral dredging on a cap and remove a cap.
- Open a key a "confidential" bolt for fastening of wheels if that costs on your car.
- To weaken bolts for fastening of wheels – everyone approximately on a turn.
- To establish an onboard jack on the basis of the car skosy inside on the designated place of bottom edge of a body (the section the workplace Organization). The jack should enter into a vertical strut of a body thus.
- On the soft earth it is necessary to enclose a plate under a jack.
- To lift the car.
- Completely to turn out bolts for wheel fastening.
- To remove a wheel, to put on a spare wheel. The aligning pin from an onboard tool kit if it before installation of a wheel to screw in a bolt opening thus can help.
- To put konsistentny or liquid greasing on a cone and a bolt carving for fastening of wheels.
- Evenly and perekrestno to tighten bolts. Thus to turn a wheel that in one, in other party in order that it was faultlessly aligned on a nave.
- To lower the car, дозатянуть bolts (110 N • м).
- To put on a cap. To pay attention to cut for a tire nipple.
- After a short trip to check strong landing of bolts.
|
|
|
|
Help: if bolts for fastening of wheels cannot be screwed in a wheel nave, the brake disk turned on a nave can be the reason. Turn it until openings will coincide.
|
|
|