Audi 80/Avant (B4)

since 1991-1995 of release

Repair and car operation


Audi 80/Avant
+ Technical specification
+ Engines
+ System of production of the fulfilled gases
+ cooling System
+ Fuel tank and fuel pump
+ Air filter and airintaking channels
+ injection System
+ Coupling
+ Transmission and transmission
+ Suspension bracket and steering
+ Brake system
+ Anti-blocking system of brakes
+ Wheels and tires
+ Body electrosystem
+ ignition System
- Lighting
   Lighting check
   Spare lamps
   Replacement of lamps
   Removal of headlights
   Check of adjustment of headlights
   Fog lights
   Independent installation of fog lights
   Indexes of turns
   Back lamps
   Illumination of registration plates
   Other lighting devices
   Dashboard illumination
+ Signalling devices
+ Devices and auxiliary devices
+ Heating and ventilation
+ body Elements
+ Search of malfunctions
+ Specifications



Dashboard illumination

The boss and the filament lamp of illumination of devices make a whole. On an illustration the lamp is turned out (arrow).

At the left: for illumination of regulators of heating three small bulbs (3, 4 and 5) answer. For replacement to separate the rotary switch (1), to weaken bolts (shooters) and to remove the panel (2).

On the right: illumination of a motor compartment: a few to compress from sides the top part of the lamp (1) and to take out it from grooves. Then there is available a sofitny lamp.

Ashtray and lighter illumination:

1–the built-in panel;
2–six-sided bolt;

3–bulb.

The block of illumination of a ware box on an illustration is presented entirely pulled out of fastening (1)

2–connecting wire;
3–bulb;

4–button.

Illumination of devices

Here illumination of devices is considered only. About the indicators which have been also located in a combination of devices, you will read Devices and auxiliary devices in head.

 PERFORMANCE ORDER

  1. To remove a steering wheel (head the Suspension bracket of wheels and a steering).
  2. To remove the block of a combination of devices (head Devices and auxiliary devices).
  3. Behind on a combination of devices to turn the boss of a lamp of illumination of devices to the left and to take out it.
  4. Lamps with a glass socle form a whole with the boss.
  5. The boss with a lamp again to insert into the block of a combination of devices and to turn to the right against the stop.

Posvetka of the heater panel

 PERFORMANCE ORDER

  1. To remove handles of three rotary regulators of system of heating and ventilation.
  2. To turn out two screws located below with a crosswise shliyets. To remove the panel.
  3. Now three bulbs with glass socles are visible.
  4. Bulbs can be got from the boss on one.

Ashtray and lighter illumination

 PERFORMANCE ORDER

  1. To take out a plug-in part of an ashtray.
  2. To turn out a long face key a six-sided bolt behind the lighter.
  3. To overturn the built-in panel of the lighter and to take out a cartridge of a lamp from the bottom party.
  4. To get from the boss a lamp with a glass socle.
  5. At the cars equipped with additional devices, the lighter is located near the lever of the parking brake.
  6. For replacement of lamps to remove a back part of the central console.
  7. Lighter illumination at the car with additional devices: to remove the tsetralny console.

Illumination of a ware box

The plafond of illumination of a ware box contains the contact switch in one case. A food arrives only at included dimensional light or light of headlights.

 PERFORMANCE ORDER

  1. On a reverse side of a ware box to turn to the left 4-ваттную an incandescence bulb (it is necessary to reconstruct the representation: the lamp shows forward on a course) and to extend up (the bayonetny zamkovy device).
  2. For removal of all block to separate tips and to squeeze out a cartridge from fastening in the direction to salon.

Illumination of the indicator of an AKP mode

For illumination of the indicator of an AKP mode on the selector lever at the included ignition the lamp with a glass socle (1,2 W, a DIN form W) serves.

 PERFORMANCE ORDER

  1. To remove the central console, see the section Salon.
  2. To unscrew a cartridge of a bulb from the console of the lever of the AKP selector.
  3. To take out a bulb with a glass socle from the boss.

Illumination of additional devices

 PERFORMANCE ORDER

  1. To remove the central console, see the section Salon.
  2. To turn to the left cartridges of lamps on a reverse side of the block of additional devices and to remove them.