Audi 80/Avant (B4)

since 1991-1995 of release

Repair and car operation



Audi 80/Avant
+ Technical specification
+ Engines
+ System of production of the fulfilled gases
+ cooling System
+ Fuel tank and fuel pump
+ Air filter and airintaking channels
+ injection System
+ Coupling
+ Transmission and transmission
+ Suspension bracket and steering
+ Brake system
+ Anti-blocking system of brakes
+ Wheels and tires
+ Body electrosystem
+ ignition System
+ Lighting
+ Signalling devices
+ Devices and auxiliary devices
+ Heating and ventilation
- Body elements
   Front bumpers
   Forward part of the car
   Cowl
   Wings
   Moldings
   Doors
   External rear-view mirrors
   The forward and back flew down
   Trunk lid at a sedan
   Back door of the versatile person
   Rear bumper
   Movable hatch
   Pro-cleaning of openings for a water drain
   Control of anticorrosive protection of the bottom of a body
   Salon
   Seats
+ Search of malfunctions
+ Specifications





Rear bumper

For removal of a rear bumper it is necessary to weaken on the right and left parties of the car on two six-sided bolts. On an illustration fixing bolts of a sedan are shown.


If the trunk lid of a sedan knocks or sits incorrectly, it is possible to adjust locking plate (3) behind at a floor of a luggage compartment. For this purpose it is necessary to weaken both screws (arrow). The locking plate becomes an available covering after removal of loading edge (1) or after removal of a small cover (2) in a covering.

Removal

 PERFORMANCE ORDER

  1. Version sedan: to cast away a rug of a luggage compartment.
  2. Version versatile person: to remove behind a door covering.
  3. To cast away a rug of a luggage compartment.
  4. To remove from clamps a lateral covering of a luggage compartment – only behind.
  5. Slightly to delay aside a lateral covering, to enter from above between a covering and a back wing a face natural the extension piece (length about 500 mm) with a replaceable head and kardany and to put on it fixing bolts of a bumper.
  6. To turn out bolts.
  7. All models: to turn out in a luggage carrier on the right and at the left on two six-sided bolts.
  8. To turn out on the right and at the left on two screws-samoreza, connecting a bumper and a podkrylok.
  9. To separate lateral faces of a bumper from body arms.
  10. For this purpose strongly to press a bumper sideways down and at the same time to delay it for the upper edge from a body.
  11. To remove a bumper, raising on both ends over podkrylka.
  12. At bumper installation at first to insert back fastenings.
  13. Lateral faces of a bumper at first to insert into arms on a body bottom edge. Then to press them sideways above that the top fixing points were fixed also. To watch for fixing brackets on bottom edge of a bumper.
  14. To lift podkrylka over the ends of a bumper and to connect them bolts.
  15. Versatile person: bumper regulation on height is made by moving of fastening of a bumper. The distance between bottom edge of lateral back wings and a bumper should make 6,5–7,5 mm