Audi 80/Avant (B4)

since 1991-1995 of release

Repair and car operation

Audi 80/Avant
+ Technical specification
- Engines
   Basic elements
   Greasing system
   Case ventilation
   Visual check of the engine
   Running in of the new engine
   Engine service life
   Nominal and maximum frequency of rotation
   Restriction of frequency of rotation
   Measurement of pressure of compression
   List of malfunctions
   Provorachivaniye of the engine
   Hydraulic pushers
   Works on the GRM gear belt
   List of malfunctions
   Removal and installation of a head of the block of cylinders
   Removal and engine installation
+ System of production of the fulfilled gases
+ cooling System
+ Fuel tank and fuel pump
+ Air filter and airintaking channels
+ injection System
+ Coupling
+ Transmission and transmission
+ Suspension bracket and steering
+ Brake system
+ Anti-blocking system of brakes
+ Wheels and tires
+ Body electrosystem
+ ignition System
+ Lighting
+ Signalling devices
+ Devices and auxiliary devices
+ Heating and ventilation
+ body Elements
+ Search of malfunctions
+ Specifications

Removal and engine installation

The description of removal of the engine for all types of engines would leave far for a framework of this management. Here only some essential points concerning this subject are given.

The engine is taken out up without a transmission. For this purpose it is required to you полиспаст (таль) which you can strongly suspend at sufficient height. It is even better, if you have an assistant who already have experience.
Before the beginning actually works on removal of the engine it is necessary to remove all stirring parts of the car: cowl, bottom protection of the engine, case of the air filter, storage battery and if necessary radiator.
As in the Audi 80 car the large quantity of electric wires and vacuum pipelines is established, you should mark out first of all them everything in summary to establish them everything on the right place.
Before shutdown of the storage battery you should be convinced available at you a number protective code of the anticreeping coding of an autoradio tape recorder.
The storage battery should be disconnected only at the switched-off ignition, differently it is possible to damage control units.
Before it is final отфланцовывать the engine, it is necessary to bring under a transmission a support from below or slightly to raise it together with even built-in engine. In a workshop for this purpose apply the special tool which rests against the region of fastening of a wing of the car.
The engine is supplied with pendant eyes into which it is possible to insert the tool for lifting. Watch careful fixing of a cable.

Inhaling moments

Moment of an inhaling, N • m	The 4-cylinder	The 5-cylinder	The 6-cylinder
Protective guard of a box of transfers/engine	10	—	—
Exhaust pipe at a final collector	35	35	35
Exhaust pipe at a transmission arm	25	25	25
The engine near transmission М8, М10, М12	20, 55 —	20, 45, 65	25, 45, 65
The engine bearing near an arm of a support of the engine	35	45	35
The torque converter on a flywheel	35	35	35
Torque support at the engine	25	45	—

Illustrations show two important steps at engine removal (the 6-cylinder engine is represented): in a workshop the engine acts in film by means of such adaptation for engine lifting. Only for this purpose the engine has fixing eyes into which, of course, it is possible to insert and chains or ropes. The image on the right shows the so-called basic device (1) which here is integrated with the holder of a transmission (2). Sense in giving a support to a transmission which otherwise at the removed engine would settle down. The same effect can achieve if to bring under a transmission a support from below.