Audi 80/Avant - Technical specification Engines Transmissions Body Chassis 15-inch wheels Brake system Seats Passive safety Full drive Distributive Torsen-differential Dynamics of movement at a dry paving Instructions on operation for all-wheel drive cars Blocking of differential of the back bridge Motor compartment Regular servicing Workplace organization Lubricant works Consumption of oil Right choice of engine oil Replacement of engine oil and oil filter Check of level of working liquid of the amplifier of a wheel Check of level of oil of a mechanical transmission Check of level of oil in a drive of the back bridge Control of level of ATF in an automatic transmission Check of level of oil in the main transfer of an automatic transmission ATF replacement Greasing of hummock drives, hinges and locks + Engines + System of production of the fulfilled gases + cooling System + Fuel tank and fuel pump + Air filter and airintaking channels + injection System + Coupling + Transmission and transmission + Suspension bracket and steering + Brake system + Anti-blocking system of brakes + Wheels and tires + Body electrosystem + ignition System + Lighting + Signalling devices + Devices and auxiliary devices + Heating and ventilation + body Elements + Search of malfunctions + Specifications
|
Replacement of engine oil and oil filter
|
The carving stopper of a masloslivny opening can be got only after removal of the bottom protection of a motor compartment. The cap key best of all will be suitable for untwisting. |
|
Thus the oil filter (1) by means of a key collar (2) is turned off. On an illustration the filter of the 4-cylinder engine is shown. |
|
- Oil needs to be changed only on the heated-up engine! If necessary it is possible to be passed a little to warm up the motor.
- The Audi 80 car whenever possible to lift and fix horizontally (on support!) or to tire out on a platform.
- To remove the bottom protection of a motor compartment, see head about a body.
- To substitute under the oil pallet a suitable vessel.
- To open a carving stopper of a masloslivny opening a ring key. Let's to oil flow down. Carefully, it is hotter!
- If you raised the car only in front, for the fulfilled oil full plum it is necessary to lower the car once again. Watch, that thus the capacity with the fulfilled oil was not damaged or overturned.
- To substitute capacity for the fulfilled oil under the oil filter.
- To unscrew the oil filter by means of a key collar. At very densely sitting filter to punch a screw-driver a filter wall (it is careful, follows hot oil) and to scroll the filter.
- Slightly to grease with plastic greasing a sealing ring on the new oil filter. Not to apply for this purpose oil because at visual control it is easily erroneous for taking for following oil.
- To wrap the oil filter a hand without use of any tools.
- To wipe dry and absolutely carving stopper of a maslozalivny mouth and to screw it with a new sealing ring; carefully, not to damage directing carving in the oil pallet.
- To fill in oil (see the table).
- To get the engine, to check oil on an effluence.
|
|
Amount of oil
Engine oil
|
4-cylinder engine
|
5-cylinder engine
|
6-cylinder engine
|
Amount of oil without replacement фильтра* |
2,5 l |
3,5 l |
4,5 l |
Amount of oil with filter replacement |
3,0 l
|
4,0 l |
5,0 l |
* Only at oil replacement between recommended intervals
|
|