Audi 80/Avant (B4)

since 1991-1995 of release

Repair and car operation



Audi 80/Avant
- Technical specification
   Engines
   Transmissions
   Body
   Chassis
   15-inch wheels
   Brake system
   Seats
   Passive safety
   Full drive
   Distributive Torsen-differential
   Dynamics of movement at a dry paving
   Instructions on operation for all-wheel drive cars
   Blocking of differential of the back bridge
   Motor compartment
   Regular servicing
   Workplace organization
   Lubricant works
   Consumption of oil
   Right choice of engine oil
   Replacement of engine oil and oil filter
   Check of level of working liquid of the amplifier of a wheel
   Check of level of oil of a mechanical transmission
   Check of level of oil in a drive of the back bridge
   Control of level of ATF in an automatic transmission
   Check of level of oil in the main transfer of an automatic transmission
   ATF replacement
   Greasing of hummock drives, hinges and locks
+ Engines
+ System of production of the fulfilled gases
+ cooling System
+ Fuel tank and fuel pump
+ Air filter and airintaking channels
+ injection System
+ Coupling
+ Transmission and transmission
+ Suspension bracket and steering
+ Brake system
+ Anti-blocking system of brakes
+ Wheels and tires
+ Body electrosystem
+ ignition System
+ Lighting
+ Signalling devices
+ Devices and auxiliary devices
+ Heating and ventilation
+ body Elements
+ Search of malfunctions
+ Specifications




55722 запасные части автокран Ивановец КС.

Greasing of hummock drives, hinges and locks

The plan of service of Audi provides only a few lubricant works on a car body. However life shows that periodic greasing helps to remain legkokhodny to some places of a body, from among what usually creak, get stuck, are torn or rust. Thus it is necessary to consider the following basic rule: with narrow passes to which plastic greasing gets with great difficulty, it is better to oil hinges or lubricant spray. It is better to grease rubbing open surfaces with konsistentny greasing because these greasings keep better.

Doors and trunk lid

 PERFORMANCE ORDER

  1. Door Audi hinges do without servicing. But after all it is better to grease them with a small amount of oil from time to time.
  2. It is better to grease small rychazhka of door stoppers of the bottom door hinge with universal konsistentny greasing.
  3. Locks of doors, it is possible to process covers of a luggage compartment or the fifth door aerosol greasing.
  4. You can spray trunk lid hinges a small amount of oil.

Locking cylinders

  • At least before the beginning of a cold season it is necessary to sprinkle with spray isolating and deleting a rust in a lock cut.
  • It greases, forces out humidity and protects in the winter from a rust, and also a primerzaniye.
  • It greases, forces out humidity and protects in the winter from a rust, and also a primerzaniye.

Cowl

Into place, where the hummock drive leaves a cover, to put a little plastic greasing and to involve a cable in a cover by means of repeated pressing the lever. If on your car there is a 5-cylinder engine, for carrying out this operation it will be necessary to uncover a radiator.

 PERFORMANCE ORDER

  1. It is necessary to grease locking pins of a cowl and both closing levers of a cover of a cowl with a small amount of plastic greasing or to put greasing spray.
  2. Hinges of a cowl and its latch should be oiled or lubricant spray.

Hatch

 PERFORMANCE ORDER

  1. Directing to process a small amount of a lubricant aerosol.
  2. To watch, that lubricant means did not get on a hatch and ceiling upholstery.
  3. To remove superfluous greasing.